[CMake] How to force the configure step to start over

[tmp]

Thanks,

I'd prefer that, but unfortunately, this is not possible atm.

On Tue, Nov 2, 2010 at 7:45 PM, David Cole <david.cole at kitware.com> wrote:

> Elminate the circularity. You'll drive yourself mad.
>
> :-)
>
>
> On Tue, Nov 2, 2010 at 2:38 PM, tmp
> <template.meta.programmer at googlemail.com> wrote:
> > Hi all,
> >
> > I have got some circular dependencies in my source that origin from
> > internal cache variables managed in different parts of my project.
> > Unfortunately there is no correct order to include the subprojects:
> > Sometimes A B C would be correct, sometimes B C A, sometimes C A B.
> >
> > At the moment I check, if the affected variables have changed during the
> > inclusion of the subprojects.
> > If there has been a change I issue an error message telling the user to
> > re-run configure.
> > If the variables have not changed, I can be sure, that all subprojects
> act
> > on the same
> > settings and no error is issued.
> >
> > I'm looking for a neater solution. Ideally I would want to start over the
> > configure step, so that
> > everything works out fine and no direct action from the user is required.
> >
> > Regards
> >
> > tmp
> >
> > _______________________________________________
> > Powered by www.kitware.com
> >
> > Visit other Kitware open-source projects at
> > http://www.kitware.com/opensource/opensource.html
> >
> > Please keep messages on-topic and check the CMake FAQ at:
> > http://www.cmake.org/Wiki/CMake_FAQ
> >
> > Follow this link to subscribe/unsubscribe:
> > http://www.cmake.org/mailman/listinfo/cmake
> >
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.cmake.org/pipermail/cmake/attachments/20101115/f81b961c/attachment.htm>